DTC 14

DTC 14: Motor Stuck ON

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0).
4. Turn the ignition switch to ON (II).
5. Wait at least 2 minutes.
6. Check for DTCs with the HDS.

Is DTC 14 indicated?

YES - Go to step 7.

NO - Intermittent failure, the system is OK at this time. Check for loose terminals at the servo unit 25P connector. Refer to intermittent failures troubleshooting.

7. Turn the ignition switch to LOCK (0).
8. Check for brake fluid leakage at the servo unit and the power unit hose and line joints.

Is there a fluid leak?

YES - Repair the brake fluid leak.

NO - Go to step 9.

9. With the ignition switch in LOCK (0), press the brake pedal 20 times.
10. Turn the ignition switch to ON (II).
11. Check for DTCs with the HDS.

Is DTC 14 indicated?

YES - Replace the servo unit.

NO - If DTC 11 is indicated, do the DTC 11 troubleshooting. DTC 11 If no DTC are indicated the system is OK at this time. Check for loose terminals at the servo unit.