DTC 18-11

DTC 12-11: Right-front Wheel Speed Sensor Electrical Noise or Intermittent Interruption

DTC 14-11: Left-front Wheel Speed Sensor Electrical Noise or Intermittent Interruption

DTC 16-11: Right-rear Wheel Speed Sensor Electrical Noise or Intermittent Interruption

DTC 18-11: Left-rear Wheel Speed Sensor Electrical Noise or Intermittent Interruption

NOTE: These DTCs may be caused by electrical interference. Check for aftermarket devices installed in the vehicle when these DTCs are indicated.

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Test-drive the vehicle.

NOTE: Drive the vehicle on a straight section of road, not on a lift.

4. Check for DTCs with the HDS.

Is DTC 12-11, 14-11, 16-11, and/or 18-11 indicated?

YES - If the DTC 12-12, 14-12, 16-12, or 18-12 is indicated at the same time, do the DTC 12-12, 14-12, 16-12, or 18-12 troubleshooting. Manufacturer Code Charts If DTC 12-12, 14-12, 16-12, or 18-12 is not indicated, go to step 5.

NO - Troubleshoot the indicated DTC. If there are no DTCs indicated, there may be an intermittent failure; the system is OK at this time. Check for loose terminals between the wheel speed sensor 2P connector and the ABS modulator-control unit 25P connector. Refer to intermittent failures troubleshooting.

5. Turn the ignition switch to LOCK (0).
6. Check that the appropriate wheel speed sensor is properly mounted.





Is the wheel speed sensor installation OK?

YES - Check for loose terminals in the ABS modulator-control unit 25P connector. If necessary, substitute a known-good ABS modulator-control unit, and retest.

NO - Reinstall the wheel speed sensor, and check the mounting position.