DTC 52

C 52: Motor Circuit OFF

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Turn the ignition switch to LOCK (0).
4. Turn the ignition switch to ON (II).
5. Wait until the power unit stops operating (When you hear the motor stop.).
6. Check for DTCs with the HDS.

Is DTC 52 indicated?

YES - Replace the servo unit.

NO - Intermittent failure, the system is OK at this time. Check for loose terminals at the power unit 2P connector and the servo unit 25P connector. Refer to intermittent failures troubleshooting.