DTC 62

DTC 62: Control Unit High Voltage

1. Turn the ignition switch to ON (II).
2. Clear the DTC with the HDS.
3. Start the engine, then wait 10 seconds.
4. Check for DTCs with the HDS.

Is DTC 62 indicated?

YES - Go to step 5.

NO - Intermittent failure, the system is OK at this time. Check for loose terminals at the servo unit 25P connector. Refer to intermittent failures troubleshooting.

5. Turn the ignition switch to LOCK (0).
6. Start the engine.
7. Check the 12 V battery voltage.

Is the voltage OK?

YES - Replace the servo unit.

NO - Do the charging system indicator circuit troubleshooting, then go to step 1 and recheck.