P0752

DTC P0751: Shift Solenoid Valve A Stuck OFF

DTC P0752: Shift Solenoid Valve A Stuck ON

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot with the HDS, and review General Troubleshooting Information.

1. Warm up the engine to normal operating temperature (the radiator fan comes on).
2. Make sure that the transmission is filled to the proper level, and check for fluid leaks.
3. Drain the ATF through a strainer. Inspect the strainer for metal debris or excessive clutch material.

Does the strainer have metal debris or excessive clutch material?

YES - Replace the transmission, then go to step 12.

NO - Replace the ATF, then go to step 4.

4. Turn the ignition switch to ON (II).
5. Clear the DTC with the HDS.
6. Select Shift Solenoid Valve A in the Miscellaneous Test Menu, and check it operates with the HDS.

Is a clicking sound heard?

YES - Go to step 7.

NO - Replace shift solenoid valve A, then go to step 10.

7. Test-drive the vehicle with the shift lever in D, and let the transmission shift through all five gears.
8. Turn the ignition switch to LOCK (0). Repeat the test-drive in step 7, then go to step 9.
9. Monitor the OBD STATUS for P0751 or P0752 in the DTCs MENU with the HDS.

Does the HDS indicate FAILED?

YES - Repair shift valve A, or replace the transmission, then go to step 12.

NO - If the HDS indicates PASSED, intermittent failure, the system is OK at this time. If the HDS indicates NOT COMPLETED, go to step 7.

10. Turn the ignition switch to ON (II).
11. Clear the DTC with the HDS.
12. Test-drive the vehicle with the shift lever in D, and let the transmission shift through all five gears.
13. Turn the ignition switch to LOCK (0). Repeat the test-drive in step 12, then go to step 14.
14. Check for DTCs with the HDS.

Is DTC P0751 or P0752 indicated?

YES - Go to step 5.

NO - Go to step 15.

15. Monitor the OBD STATUS for P0751 or P0752 in the DTCs MENU with the HDS.

Does the HDS indicate PASSED?

YES - Troubleshooting is complete. If any other DTCs were indicated in step 14, go to the indicated DTC's troubleshooting.

NO - If the HDS indicates FAILED, go to step 5. If the HDS indicates NOT COMPLETED, go to step 12.