Trunk / Liftgate Latch: Service and Repair

Trunk Lid Latch Replacement

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the trunk lid.
- Take care not to kink the trunk lid opener cable.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Insert a trim tool through the latch cover (A) opening, and pry on the cover to release the hooks (B). Pull out the cover, and release the tab (C) from the trunk lid latch (D), then remove the latch cover.





2. Disconnect the trunk lid latch connector (E), and remove the bolts, then remove the trunk lid latch.

3. Disconnect the trunk lid opener cable (A).






4. Install the latch in the reverse order of removal, and note these items:

- Make sure the connector is plugged in properly and the cable is connected properly.
- Make sure the trunk lid opens properly and locks securely.
- Fix the original position of the outer end of cable (A) on the trunk lid latch securely. And check the trunk lid latch operation: Make sure the trunk lid latch unlock when pulling the trunk lid opener/fuel fill door opener. If necessary, adjust the position of the cable end.