ODS Unit Replacement

ODS Unit Replacement

Removal

1. Do the battery terminal disconnection procedure Procedures, then wait at least 3 minutes before starting work.

2. Remove the front passenger's seat Front Seat Removal/Installation:

3. Turn over the seat-back cover/pad as needed:

- 4-door Front Seat-back Cover Replacement (4-Door)
- 2-door Front Seat-back Cover Replacement (2-Door)

4. Remove the cover (A), then disconnect the ODS unit 18P connector (B) and OPDS sensor connectors (C) from the ODS unit (D).





5. Remove the two washers, nuts (E), and the ODS unit.

Installation

1. Place the ODS unit (A) on the seat-back frame. Install the two washers and nuts, and torque the two nuts (B), then connect the ODS unit harness 18P connector (C) and OPDS sensor connectors (D) to the ODS unit. Reinstall the cover (E).





2. Install the seat-back cover cover/pad in the reverse order of removal:

- 4-door Front Seat-back Cover Replacement (4-Door)
- 2-door Front Seat-back Cover Replacement (2-Door)

3. Install the front passenger's seat Front Seat Removal/Installation.

4. Do the battery terminal reconnection procedure Procedures.

5. Clear any DTCs with the HDS Reading and Clearing Diagnostic Trouble Codes.

6. Set the seat-back in the normal position, and make sure there is nothing on the front passenger's seat.

7. Do the ODS unit initialization Programming and Relearning.

8. Confirm proper SRS operation: Turn the ignition switch to ON (II); the SRS indicator should come on for about 6 seconds and then go off.