Front Seat Recline Cover Removal/Installation

Front Seat Recline Cover Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*Available through the Honda Tool and Equipment Program, 888-424-6857

SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Take care not to tear or damage the seat covers.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.
- When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.

Outer recline cover

1. Remove the front seat Front Seat Removal/Installation.

2. Pull back the cap (A) to release the hooks (B), and remove the screws, then remove the height handle (C).






3. Remove the outer recline cover (A).

1. Fold back the seat fully.

2. Remove the recline knob (B), and remove the screw.

3. Using the appropriate trim tool, release the hooks (C) of the outer cover from the recline inner cover (D).

4. Detach the clip and the hook (E) by pulling the outer cover back by hand.

5. Gently pull out the outer cover and remove it.

Driver's seat





Passenger's seat






Center recline cover

4. Remove the center recline cover (A).

1. Using the appropriate trim tool, release the hooks (B) of the center cover from the recline inner cover (C).

2. Detach the clip, then remove the center cover.






Recline inner cover

5. Remove the front seat cushion cover/pad.

6. Remove the front seat-back cover/pad Front Seat-Back Cover Replacement.

7. Remove the recline inner cover (A).

1. Release the hooks (B) of the recline inner cover from the seat cushion frame.

2. Detach the cover from the seat cushion frame tube (C), and remove the cover.

Driver's outer recline inner cover





Driver's inner recline inner cover





Passenger's outer recline inner cover





Passenger's inner recline inner cover





8. When installing the inner cover, securely fit the hooks on the seat cushion frame first, then fit the holder of the cover on the seat cushion frame tube.