Dashboard Center Vent Removal/Installation (With Navigation)

Dashboard Center Vent Removal/Installation

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

With Navigation System

NOTE:

- Take care not to scratch the dashboard or the related parts.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Apply the protective tape (A) to the dashboard middle pad beside both side edges of the dashboard center vent (B). Pry up on the edge of the center vent with the appropriate trim tool to detach the clips (C, D).






2. Pull out the dashboard center vent (A) by hand to detach the clips and release the projections (B) from the holes in the center display visor (C), then remove the center vent.





3. Disconnect the hazard warning switch/passenger's airbag cutoff indicator connector (D) and the navigation subdisplay connector (E). Detach the harness clip (F), and release the wire harness (G) from the harness holder (H).

4. Install the center vent in the reverse order of removal, and note these items:

- If the clips are damaged or stress-whitened, replace them with new ones.
- Make sure each connector is plugged in properly.
- Push the harness clip and the clips into place securely.