Glove Compartment: Service and Repair

Glove Box Removal/Installation

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

NOTE: Take care not to scratch the dashboard or the related parts.

1. Remove these items:

- Passenger's middle panel Dashboard Passengers Middle Panel Removal/Installation
- Passenger's dashboard undercover Passenger's Dashboard Undercover Removal/Installation

2. Open the glove box.

3. Remove the screws (A) and the bolts (B).





4. Close the glove box.

5. Pull out the glove box (A) by hand to detach the clips.





6. Disconnect the glove box light connector (B), then remove the glove box.

Glove box lid replacement

7. If necessary, open the glove box.

8. Remove the glove box lid (A).

1. Detach the upper hooks (B) of the lid.

2. Detach the lower hooks (C) of the lid.





9. Install the box in the reverse order of removal, and note these items:

- Push the clips and the hooks into place securely.
- Make sure the connector is plugged in properly.