Windshield Wiper Motor Replacement

Windshield Wiper Motor Replacement

Removal

NOTE: Be careful not to scratch or damage the hood and the body.

1. Remove the windshield wiper arms Service and Repair.

2. Remove the under-cowl panel and the hood hinge cover Service and Repair.

3. Disconnect the 5P connector (A), and remove the cover (B) from the windshield wiper motor (C).





4. Remove the four bolts and the wiper linkage assembly (D).

5. Mark lines (A) to show the original adjustment, then remove the connection rod (B) from the linkage (C).





6. Remove the nut, and separate the linkage from the windshield wiper motor (D).

7. Remove the three bolts, and separate the windshield wiper motor from the linkage assembly (E) through the hole.

Installation

1. Before installing the motor, connect the 5P connector to the wiper motor, and turn the windshield wiper/washer switch ON to (LO) or (HI) position, then OFF to return the motor shaft to the park position.

NOTE:

- Do not use the windshield wiper/washer switch INT position in this step.
- Apply multipurpose grease to the moving parts.

2. Install the wiper motor to the wiper linkage assembly in the reverse order of removal.

3. Install the linkage to the wiper motor shaft, then align the mark (A) of the linkage and the mark (B) of the wiper linkage assembly.





4. After installation, adjust the wiper arms Adjustments.