Front Seat Rail Replacement - Passengers Seat

Front Seat Rail Replacement - Passenger's Seat

Special Tools Required

- KTC Trim Tool Set SOJATP2014
*

Removal

SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Put on gloves to protect your hands.
- Use the appropriate tool from the KTC trim tool set to avoid damage when removing components.

1. Do the battery terminal disconnection procedure, then wait at least 3 minutes before starting work.

2. Remove the front seat Front Seat Removal/Installation.

3. Remove these items:

- Front seat-back cover/pad Front Seat-Back Cover Replacement
- Front seat cushion cover/pad Front Seat Cushion Cover Replacement
- Recline inner cover/center inner cover

4. Remove the TORX nuts fastening the seat frame (A) to the front passenger's weight sensors (B) with a TORX E18 socket.





5. Disconnect the sensor connectors (C) from the front passenger's weight sensors, then remove the front passenger's seat rail assembly (D) including both passenger's weight sensors.

Installation

SRS components are located in this area. Review the SRS component locations Locations, and the precautions and procedures Service and Repair before doing repairs or service.

NOTE:

- Make sure to install the harness wires so they are not pinched or interfering with other parts.
- The spacers and collars can be identified by their color.

1. Loosely tighten the new nuts and install the new front passenger's seat rail assembly under the seat frame.

NOTE: The spacers and collars can be identified by their color.










2. When tightening the TORX nuts (A), tighten them in a crisscross pattern in two or more steps.





3. Connect the sensor connectors (B) to the front passenger's weight sensors.

NOTE: The sensor connectors with the white tape (C) connect to the front passenger's weight sensors.

4. Reinstall these items:

- Recline inner cover/center inner cover
- Front seat cushion cover/pad Front Seat Cushion Cover Replacement
- Front seat-back cover/pad Front Seat-Back Cover Replacement

5. Reinstall the front seat Front Seat Removal/Installation.

6. Do the battery terminal reconnection procedure.

7. Connect the HDS and clear the DTCs.

8. Do the front passenger's weight sensor initialization, after front passenger's seat rail replacement.

9. Confirm proper SRS operation: Turn the ignition switch to ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

10. Check the seat slide operation.