Engine Oil: Service and Repair

Engine Oil Replacement

1. Warm up the engine.

2. Remove the drain bolt (A), and drain the engine oil.





3. Reinstall the drain bolt with a new washer (B) and torque to specification.

4. Refill the engine with the recommended oil [1][2]Fluids.










5. Run the engine for more than 3 minutes, then check for oil leakage.

6. If the Maintenance Minder required replacing the engine oil, reset the Maintenance Minder Description and Operation, when this procedure is complete. If the Maintenance Minder did not require engine oil replacement, go to step 7.

7. Turn the ignition switch to LOCK (0).

8. Connect the HDS to the DLC.

9. Turn the ignition switch to ON (II).

10. Make sure the HDS communicates with the vehicle and the ECM/PCM. If it does not communicate, troubleshoot the DLC circuit Testing and Inspection.

11. Select GAUGE in the BODY ELECTRICAL with the HDS.

12. Select ADJUSTMENT in GAUGES with the HDS.

13. Select RESET in the MAINTENANCE MINDER with the HDS.

14. Select RESETTING THE ENGINE OIL LIFE with the HDS.

NOTE: If you changed the automatic transmission fluid (ATF) at the same time with the engine oil, select RESETTING THE ENGINE OIL LIFE AND ATF with the HDS instead.