Audio Unit Removal And Installation

Service Information

Audio Unit Removal and Installation

Removal

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Driver's Dashboard Lower Cover





1. Remove the driver's dashboard lower cover (A).

2. Disconnect the connectors.

2. Subdisplay Visor





1. Remove the subdisplay visor (A).

2. Disconnect the connector.

3. Center Console Panel





1. Detach the clips (A).





2. Remove the center console panel (A) in the order shown.

4. Center Lower Panel





1. Remove the center lower panel (A).

2. Disconnect the connectors.

5. Audio Unit Assembly




NOTE:
* Lay a workshop towel under the parts when working on them to protect the face panel from scratches or other damage.
* Do not work in a dusty or dirty place.
* Discharge static electricity from your body before and during the work.
* Do not touch the circuit board(s) with your bare hands.
* Do not work with dirty hands.
* Do not touch the terminal connector of the flat plate cable with your bare hands (If you have touched it, wipe it off thoroughly).
* Eject CD before disconnecting the audio unit to prevent damaging the CD player's load mechanism
* If you are replacing the audio unit, write down the audio presets (if possible), and enter them into the new audio unit.

1. Remove the bolts (A).





2. Disconnect the connectors, then pull out the audio unit (A).

6. Audio Unit





1. Remove the audio unit (A) from the audio switch panel (B).

Installation

SRS components are located in this area. Review the SRS component locations Locations and the precautions and procedures Service and Repair before doing repairs or service.

1. Audio Unit





1. Install the audio switch panel (A) to the audio unit (B).

2. Audio Unit Assembly





1. Connect the connectors, then install the audio unit (A).





2. Install the bolts (A).

3. Center Lower Panel





1. Install the center lower panel (A).

2. Connect the connectors.

4. Center Console Panel





1. Install the center console panel (A) in the order shown.





2. Install the clips (A).

5. Subdisplay Visor





1. Install the subdisplay visor (A).

2. Connect the connector.

6. Driver's Dashboard Lower Cover





1. Connect the connectors.

2. Install the driver's dashboard lower cover (A).