Power Mirror Replacement

Power Mirror Replacement

NOTE:

- Put on gloves to protect your hands.
- Take care not to scratch the door or related parts.

1. Carefully pull the bottom edge of the mirror mount cover (A) out to release the lower hooks (B), and remove the cover by lifting it upward to release the upper hooks (C, D).





2. Remove the front door panel Service and Repair.

3. Raise the glass fully.

4. Remove the plastic cover as needed, then disconnect the connector (A), and detach the harness clip (B).






5. While holding the mirror (A), remove the nuts.






6. Remove the mirror (A) by pulling the threaded studs (B), the screw (C), and the wire harness (D) out through the holes in the door. Take care not to scratch the door or the mirror.





7. Install the mirror in the reverse order of removal, and note these items:

- Make sure the connector is plugged in properly.
- Push the clip and hooks into place securely.