Coolant: Service and Repair

Coolant Replacement

1. Wait until the engine is cool, then carefully remove the radiator cap.

2. Remove the splash shield Splash Shield Replacement.

3. Loosen the drain plug (A), and drain the coolant.






4. Remove the drain bolt (A) located at the rear of the engine block.





5. After the coolant has drained, reinstall the drain bolt with a new washer.

6. Tighten the radiator drain plug securely.

7. Remove, drain, and reinstall the coolant reservoir.

8. Fill the coolant reservoir to the MAX mark (A) with Honda Long Life Antifreeze/Coolant Type 2 .






9. Pour Honda Long Life Antifreeze/Coolant Type 2 into the radiator up to the base of the filler neck.

NOTE:

- Always use Honda Long Life Antifreeze/Coolant Type 2. Using a non-Honda coolant can result in corrosion, causing the cooling system to malfunction or fail.
- Honda Long Life Antifreeze/Coolant Type 2 is a mixture of 50 % antifreeze and 50 % water. Do not add water.

Engine Coolant Capacities (Including the coolant reservoir capacity of 0.44 L (0.116 US gal)):










10. Loosely install the radiator cap.

11. Start the engine, and let it run until it warms up (the radiator fan comes on at least twice).

12. Turn off the engine. Check the level in the radiator, and add the recommended coolant, if needed.

13. Put the radiator cap on tightly, then start the engine again, and check for leaks.

14. Clean up any spilled engine coolant.

15. If the Maintenance Minder required engine coolant replacement, reset the Maintenance Minder Description and Operation, and this procedure is complete. If the Maintenance Minder did not require engine coolant replacement, go to step 16.

16. Turn the ignition switch to LOCK (0).

17. Connect the HDS to the DLC.

18. Turn the ignition switch to ON (II).

19. Make sure the HDS communicates with the vehicle and the ECM/PCM. If it does not communicate, troubleshoot the DLC circuit Testing and Inspection.

20. Select GAUGES in the BODY ELECTRICAL with the HDS.

21. Select ADJUSTMENT in the GAUGE with the HDS.

22. Select MAINTENANCE MINDER in the ADJUSTMENT with the HDS.

23. Select RESET in the MAINTENANCE MINDER with the HDS.

24. Select MAINTENANCE SUB ITEM 5 RESET with the HDS.