Vacuum Brake Booster: Service and Repair

Brake Booster Replacement

1. Remove the master cylinder Service and Repair.

2. Remove the front wiper arms Service and Repair.

3. Remove the cowl cover and the under-cowl panel Service and Repair.

4. Disconnect the brake booster vacuum hose (A) from the brake booster.






5. Remove the brake lines (A) from the clamp (B).






6. Remove the engine wire harness clamp (A).






7. Remove the bracket (A).





8. Remove the driver's dashboard undercover Driver's Dashboard Undercover Removal / Installation.

9. Remove the lock pin (A) and the clevis pin (B), then disconnect the yoke from the brake pedal.

NOTE: During installation, apply multipurpose grease to the joint pin in the brake pedal.





10. Remove the brake booster mounting nuts (C).

11. Remove the brake booster (A) from the engine compartment.

NOTICE
- Be careful not to damage the booster surfaces and threads of the booster stud bolts.
- Be careful not to damage or bend the brake lines or other components hoses and lines.


NOTE: Use a new booster gasket (B) during reassembly.





12. Install the brake booster in the reverse order of removal, and note these items:

- Install the master cylinder after installing the brake booster Service and Repair.
- Check the brake pedal height and free play after installing the master cylinder, and adjust it if necessary Adjustments.
- Bleed the brake system Service and Repair.