P0500

TROUBLE SHOOTING PROCEDURE





CIRCUIT DIAGRAM





HARNESS INSPECTION PROCEDURE

COMPONENT TEST PROCEDURE





1. Disconnect the speed sensor connector and remove the speed sensor.





2. Connect the positive (+) lead from battery to terminal 2 and the negative (-) lead to terminal 1.
3. Connect the positive (+) lead from tester to terminal 1 and negative (-) lead to terminal 3.
4. Turn the speed meter shaft using a flat driver.
5. Check for a voltage change from about 0 Volts to 11 Volts or more between terminals 1 and 3.
6. The voltage change should be 4 times per each revolution of the shaft.

TROUBLESHOOTING HINTS
If there is an open or short circuit in the vehicle speed sensor signal circuit, the engine may stall when decelerating to stop the vehicle.