C1318

DTC C1317 SENSOR 1 WRONG TYPE INSTALL
DTC C1318 SENSOR 2 WRONG TYPE INSTALL
DTC C1319 SENSOR 3 WRONG TYPE INSTALL
DTC C1320 SENSOR 4 WRONG TYPE INSTALL

COMPONENT LOCATION
Refer to DTC C1121. C1121

GENERAL DESCRIPTION
Refer to DTC C1121. C1121

DTC DESCRIPTION
This DTC indicates that "H/Line WE sensor" was installed to a L/Line system incorrectly.

DTC DETECTING CONDITION

DTC DETECTING CONDITION:

COMPONENT INSPECTION
1. Turn ON "TPMS exciter".
2. Select "TIRE SNSR CONFIG (EXCITER)" mode.
3. Execute "SET SENSOR STATUS" of Sensor 1/Sensor2/Sensor3/Sensor4.
4. Monitor the parameter of Sensor 1/Sensor2/Sensor3/Sensor4 on the "TPMS exciter".
Specification: "SENSOR OPTION" is "Low".





5. Is parameter within specifications?
YES
^ Substitute with a known-good TPMS receiver module and check for proper operation.
^ If the problem is corrected, replace TPMS receiver module and then go to "Verification of Vehicle Repair" procedure.

NO
^ Replace Sensor1/Sensor2/Sensor3/Sensor4 if necessary and register sensor ID with "TPMS exciter'.
^ Go to "Verification of Vehicle Repair" procedure.

VERIFICATION OF VEHICLE REPAIR
Refer to DTC C1121. C1121