P1730
P1730 A/T INTERLOCKDescription
Fail-safe function to detect interlock conditions.
DTC Logic
P1730:
NOTE: When the vehicle is driven fixed in 2nd gear, a turbine revolution sensor malfunction is displayed, but this is not a turbine revolution sensor malfunction.
DTC CONFIRMATION PROCEDURE
NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
1. CHECK DTC DETECTION
With CONSULT-III
1. Start the engine.
2. Select "Data Monitor" mode for "TRANSMISSION".
3. Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.
SLCT LVR POSI: "D" position
With GST
Follow the procedure "With CONSULT-III".
Is "P1730 A/T INTERLOCK" detected?
YES >> Go to "Diagnosis Procedure".
NO >> Check intermittent incident. Refer to GI-38, "Intermittent Incident". Service Information For Electrical Incident
Judgment of A/T Interlock
Refer to TM-111, "Fail-Safe". TCM
Diagnosis Procedure
1. CHECK TCM POWER SUPPLY AND GROUND CIRCUIT
Check TCM power supply and ground circuit. Refer to TM-89, "Diagnosis Procedure". Main Power Supply and Ground Circuit
Is the inspection result normal?
YES >> Replace the control valve with TCM.
NO >> Repair or replace damaged parts.