Shifter A/T: Service and Repair

CONTROL DEVICE

TM-158 Exploded View:

AWD: Removal and Installation

REMOVAL
1. Remove control rod from control device assembly.
2. Shift the selector lever to "N" position.





3. Remove knob cover (A) below selector lever downward.
4. Pull lock pin (1) out of selector lever knob (2).
5. Remove selector lever knob.
6. Remove console finisher assembly and center console assembly.

CAUTION: When disconnecting selector lever position indicator connector from shift position switch, never twist or apply an excessive load to the connector.

7. Remove the rear ventilator duct 1 (with rear ventilation).
8. Disconnect control device harness connector.
9. Remove harness clips from control device assembly.
10. Shift the selector lever to "P" position.
11. Move passenger's seat to the end.
12. Remove control device assembly mounting bolts.





13. Slightly lift the control device assembly (1) and slide it rightward. Then pull it out in the diagonally right direction.
14. Remove selector lever position indicator from console finisher assembly.





a. Remove ashtray (front) (1) from console finisher assembly.
(<---): Screw





b. Remove insert finisher (1) from console finisher assembly.
A: Screw (small)
B: Screw (large)





c. Remove the selector lever position indicator (1).
(<---): Screw
15. Remove adapter from control device assembly.
16. Remove dust cover and dust cover plate from control device assembly.
17. Remove dust cover plate from dust cover.
18. Remove shift lock unit from control device assembly.
19. Remove bracket from vehicle floor panel.

INSTALLATION
Note the following, and install in the reverse order of removal.
^ When installing control rod to control device assembly, refer to "ADJUSTMENT". Refer to TM-153, "AWD: Inspection and Adjustment". Testing and Inspection

AWD: Inspection and Adjustment

INSPECTION AFTER INSTALLATION
Check the A/T positions. Refer to TM-153, "AWD: Inspection and Adjustment". Testing and Inspection