Removal And Installation

BRAKE PEDAL

Removal and Installation


REMOVAL

1.Remove instrument lower panel LH. Exploded View.
2.Remove steering column assembly. Exploded View
(without electric motor), Exploded View (with electric motor).
3.Disconnect the stop lamp switch and ASCD brake switch harness connectors.
4.Disconnect the brake pedal stroke sensor harness connector (with pre-crash seat belt).

CAUTION:
Never removing brake pedal stroke sensor (with pre-crash seat belt).
5.Turn the stop lamp switch and ASCD brake switch counterclockwise to remove the stop lamp switch and
ASCD brake switch.
6.Remove snap pin and clevis pin from clevis of brake booster.
7.Remove cowl top cover. Exploded View.
8.Remove instrument panel assembly. Exploded View.
9.Slide the steering member rearward. Exploded View.
10.Remove brake pedal assembly.

INSTALLATION

Note the following, and install in the reverse order of removal.
- Apply the multi-purpose grease to the clevis pin and the mating faces. (Not necessary if grease has been already applied)
NOTE:
The clevis pin may be inserted in either direction.