Brake Pedal Assy: Adjustments

BRAKE PEDAL

Inspection and Adjustment


INSPECTION

Brake Pedal Height





Check the brake pedal height (H1) between the dash lower panel (1)
and the brake pedal upper surface.
Standard


H1: Refer to "Brake Pedal" Specifications.

CAUTION:
Remove the floor trim.
Stop Lamp Switch and ASCD Brake Switch





Check the clearance (C) between stopper rubber (1) and stop lamp switch and ASCD brake switch (2) threaded end.
Standard


C: Refer to "Brake Pedal" Specifications.

CAUTION:
The stop lamp must be turned off when the brake pedal is released.
NOTE:
Pull the brake pedal pad to make the clearance between stopper rubber and stop lamp switch and ASCD brake switch threaded end.
Brake Pedal Play





Press the brake pedal. Check the brake pedal play (A).
Standard


A: Refer to "Brake Pedal" Specifications.
Depressed Brake Pedal Height





Check the brake pedal height (H2) between the dash lower panel (1)
and the brake pedal upper surface when depressing the brake pedal at 490 N (50 kg, 110 lb) while turning engine ON.
Standard


H2: Refer to "Brake Pedal" Specifications.

CAUTION:
Remove the floor trim.

ADJUSTMENT

Brake Pedal Height
1.Remove instrument lower panel LH. Refer to "Exploded View" Exploded View.
2.Disconnect the stop lamp switch and ASCD brake switch harness connector.
3.Turn the stop lamp switch and ASCD brake switch 45� counterclockwise.





4.Loosen the input rod lock nut (1). Adjust the brake pedal height (H
1) to the specification. Tighten the input rod lock nut to the specification. Refer to "Exploded View" Exploded View.

CAUTION:
The threaded end of the input rod (2) must project to the inner side (L) of the clevis (3).





Standard


H1: Refer to "Brake Pedal" Specifications.
Stop Lamp Switch and ASCD Brake Switch
1.Remove instrument lower panel LH. Refer to "Exploded View" Exploded View.
2.Disconnect the stop lamp switch and ASCD brake switch harness connector.
3.Turn the stop lamp switch and ASCD brake switch 45� counterclockwise.





4.Press-fit stop lamp switch and ASCD brake switch (2) until stop lamp switch and ASCD brake switch hits the stopper rubber (1)
45� clockwise.

CAUTION:
- The clearance (C) between the stopper rubber and stop lamp switch and ASCD brake switch threaded end must be the specified value. Refer to "Brake Pedal" Specifications.
- The stop lamp must be turned off when the brake pedal is released.
Brake Pedal Play
1.Remove instrument lower panel LH. Refer to "Exploded View" Exploded View.
2.Disconnect the stop lamp switch and ASCD brake switch harness connector.
3.Turn the stop lamp switch and ASCD brake switch 45� counterclockwise.





4.Press-fit stop lamp switch and ASCD brake switch (2) until stop lamp switch and ASCD brake switch hits the stopper rubber (1)
45� clockwise.

CAUTION:
- The clearance (C) between the stopper rubber and stop lamp switch and ASCD brake switch threaded end must be the specified value. Refer to "Brake Pedal" Specifications.
- The stop lamp must be turned off when the brake pedal is released.