Removal and Installation

WASHER TANK

Removal and Installation


REMOVAL






1.Remove the clip (A).





2.Pull out the washer tank inlet (1) from the washer tank.
3.Remove the fender protector RH (front). Refer to "FENDER PROTECTOR : Exploded View" Exploded View.
4.Remove the engine lower cover. Refer to "Exploded View" Exploded View.
5.Disconnect washer pump connector.
6.Disconnect the washer level switch connector.
7.Remove front washer tube and rear washer tube.
8.Remove washer tank mounting bolts.
9.Remove washer tank from the vehicle.

INSTALLATION

Note the following, and install in the reverse order of removal.

CAUTION:
Add water up to the top of the washer tank inlet after installing. Check that there is no leakage.