Removal and Installation

BRAKE PEDAL

Removal and Installation


REMOVAL

1.Remove instrument lower panel LH. Refer to "Removal and Installation" Instrument Lower Panel LH.
2.Remove sonar control assembly. Refer to "Removal and Installation" With Surround Sound.
3.Disconnect the stop lamp switch and ASCD cancel switch harness connectors.
4.Disconnect brake stroke sensor harness connector (if equipped).
5.Remove wire harness clips from brake pedal assembly.
6.Remove snap pin and clevis pin from clevis of brake booster.
7.Remove the brake pedal assembly.

CAUTION:
Support the brake booster and master cylinder to prevent contact with other components.

INSPECTION AFTER REMOVAL

Revision: March 20122013 Infiniti JX





- Check the following items and replace the brake pedal assembly if necessary.
- Check the brake pedal upper rivet (made of aluminum) (A) for deformation.
- Check the brake pedal for bend, damage, and cracks on the welded parts.
- Check the overlap distance (X) of sub-bracket (B) and slide plate (C).





INSTALLATION

Installation is in the reverse order of removal.
- If pedal is being replaced and is equipped with a brake pedal stroke sensor, transfer of the brake stroke sensor is necessary. Refer to "Removal and Installation" Removal and Installation.
Revision: March 20122013 Infiniti JX