Removal and Installation

WASHER TANK

Removal and Installation


REMOVAL

1.Fully open the hood.





2.Remove the washer tank inlet clip (A) from the coolant reservoir and pull the washer tank inlet tube (1) from the washer tank.
3.Remove the front fender protector (RH). Refer to "FENDER PROTECTOR : Removal and Installation" Removal and Installation.
4.Disconnect the harness connector from the washer pump.
5.Disconnect the harness connector from the washer level switch.
6.Disconnect the front washer tube and rear washer tube.
7.Remove the washer tank bolts.
Revision: March 20122013 Infiniti JX
8.Remove the washer tank.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
Add water to the top of washer tank inlet after installing. Check that no leaks exist.
Revision: March 20122013 Infiniti JX