P0600

System Description
These circuit lines are used to control the smooth shifting up and down of A/T during the hard acceleration/ deceleration. Voltage signals are exchanged between ECM and TCM (Transmission control module).

ECM Terminals And Reference Value:

On Board Diagnosis Logic:

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

With CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.




3. Wait at least 10 seconds.
4. If DTC is detected, go to "Diagnostic Procedure".

EC-AT/C-01:

EC-AT/C-01 Connector View:

Wiring Diagram

Steps 1 - 3:

Diagnostic Procedure