P1211
DTC P1211 TCS CONTROL UNITDescription
The malfunction information related to TCS is transferred through the CAN communication line from VDC/TCS/ABS control unit to ECM.
Be sure to erase the malfunction information such as DTC not only for VDC/TCS/ABS control unit but also for ECM after TCS related repair.
On Board Diagnosis Logic:
DTC Confirmation Procedure
TESTING CONDITION:
Before performing the following procedure, confirm that battery voltage is more than 10.5 V at idle.
WITH CONSULT-II
1. Turn ignition switch "ON".
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Start engine and let it idle for at least 60 seconds.
4. If 1st trip DTC is detected, go to "Diagnostic Procedure".
WITH GST
Follow the procedure "With CONSULT-II".
Diagnostic Procedure
Go to "TROUBLE DIAGNOSIS". Initial Inspection and Diagnostic Overview