P0327

DTC P0327 KS

Component Description




The knock sensor is attached to the cylinder block. It senses engine knocking using a piezoelectric element. A knocking vibration from the cylinder block is sensed as vibrational pressure. This pressure is converted into a voltage signal and sent to the ECM.

On Board Diagnosis Logic:

DTC Confirmation Procedure

NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch "OFF" and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: Before performing the following procedure, confirm that battery voltage is more than 10 V at idle.

WITH CONSULT-II
1. Turn ignition switch "ON" and select "DATA MONITOR" mode with CONSULT-II




2. Start engine and run it for at least 5 seconds at idle speed.
3. If 1st trip DTC is detected, go to "Diagnostic Procedure".

WITH GST
Follow the procedure "With CONSULT-II" above.

EC-KS-01:

Wiring Diagram

Diagnostic Procedure (Steps 1 - 3):

Diagnostic Procedure (Steps 4 - 7):

Diagnostic Procedure (Step 8):

Diagnostic Procedure