Without Scan Tool
OPERATION PROCEDURE1. Turn ignition switch ON, and switch the odo/trip meter to "trip A" or "trip B".
NOTE: If the self-diagnosis function is activated with the "trip A" displayed, only "trip A" display is reset.
2. Turn ignition switch OFF.
3. While pushing the odo/trip meter switch, turn ignition switch ON again.
4. Make sure that the trip meter displays 0000.0".
5. Push the odo/trip meter switch at least 3 times (within 7 seconds after the ignition switch is turned ON).
6. All the segments on the odo/trip meter and A/T indicator illuminate, and simultaneously the low-fuel warning lamp indicator illuminates. At this time, the unified meter control unit is turned to self-diagnosis mode.
NOTE:
- Check combination meter power supply and ground circuit when self-diagnosis mode of combination meter does not start. Replace combination meter if the results of the check are normal.
- If any of the segments are not displayed, replace combination meter.
7. Each meter/gauge activates during pressing odo/trip meter switch. (Then low-fuel warning lamp turns OFF.)
NOTE:
- If any of the meters/gauges are not activated, replace the combination meter.
- The figure is reference.