Accelerator Pedal: Service and Repair

ACCELERATOR CONTROL SYSTEM




Components

Removal and Installation

REMOVAL
1. Disconnect accelerator pedal position sensor harness connector.
2. Loosen nuts, and remove accelerator pedal assembly.

CAUTION:
- Do not disassemble accelerator pedal assembly. Do not remove accelerator pedal position sensor from accelerator pedal assembly.
- Avoid impact from dropping etc. during handling.
- Be careful to keep accelerator pedal assembly away from water.

INSTALLATION
Install in the reverse order of removal.

INSPECTION AFTER INSTALLATION
- Make sure that accelerator pedal moves smoothly within the whole operation range.
- Make sure that accelerator pedal securely returns to the original position.
- For the electrical inspection of accelerator pedal position sensor, refer to "DTC P2123 APP SENSOR", "DTC P2127, P2128 APP SENSOR" and "DTC P2138 APP SENSOR".

CAUTION: When harness connector of accelerator pedal position sensor is disconnected, perform "Accelerator Pedal Released Position Learning". Refer to EC-78, "Accelerator Pedal Released Position Learning". Testing and Inspection