CONSULT-II Setting Procedure

CONSULT-II SETTING PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which perform CAN communication.





1. Turn ignition switch OFF.
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in instrument driver lower panel on driver side.
3. Turn ignition switch ON. (Do not start engine.)





4. Touch START (NISSAN BASED VHCL).





5. Touch A/T.
If A/T is not indicated, go to GI-38, "CONSULT-II Data Link Connector (DLC) Circuit". Electrical Diagrams





6. Perform each diagnostic test mode according to each service procedure.