Windshield Washer Reservoir: Service and Repair

FRONT WIPER AND WASHER SYSTEM


Removal and Installation of Washer Tank

: Vehicle front

REMOVAL
1. Remove engine room cover (RH). Refer to Component (VQ35HR) or Component(VK45DE).





2. Remove clip (A) and pull washer tank inlet (1) out of washer tank.
3. Remove front bumper. Refer to Standard Type.
4. Disconnect washer pump connector and wash fluid level sensor connector.





5. Remove washer tank mounting nuts (A) and remove bolt (B).
6. Remove washer tube, and remove washer tank (1) from vehicle.

INSTALLATION
Note the following, and installation is the reverse order of removal.

CAUTION:
After installation, add water up to the upper level of washer tank inlet, and check for water leaks.

Washer tank mounting nuts : 4.5 N�m (0.46 kg-m, 40 in-lb)
Washer tank mounting bolt : 4.5 N�m (0.46 kg-m, 40 in-lb)