Inspection

FRONT WHEEL HUB AND KNUCKLE


Inspection


MOUNTING INSPECTION
Make sure that the mounting conditions (looseness, backlash) of each component and component conditions
(wear, damage) are normal.

WHEEL BEARING INSPECTION
- Move wheel hub and bearing assembly in the axial direction by hand. Make sure there is no looseness of wheel bearing.

Standard
Axial end play : Refer to FAX-9, "Wheel Bearing". Front Axle

- Rotate wheel hub and bearing assembly and make sure that is no unusual noise or other irregular conditions. If there is any of irregular conditions, replace wheel hub and bearing assembly.





FRONT WHEEL HUB AND KNUCKLE


Inspection


INSPECTION AFTER REMOVAL
Check components for deformation, cracks, and other damage. Replace if necessary.

Ball Joint Inspection
Check boots of transverse link and steering outer socket ball joint for breakage, axial play, and torque. Testing and Inspection

INSPECTION AFTER INSTALLATION
- Check wheel sensor harness for proper connection. Exploded View.
- Check wheel alignment. Front Suspension.
- Adjust neutral position of steering angle sensor. Description Special Repair Requirement Description Special Repair Requirement, "ADJUSTMENT OF STEERING ANGLE
SENSOR NEUTRAL POSITION : Special Repair Requirement".