C1205

TROUBLE DIAGNOSIS FOR SYSTEM


DTC C1205 AWD ACTUATOR RELAY


CONSULT-III REFERENCE VALUE IN DATA MONITOR MODE






DIAGNOSTIC PROCEDURE
- Check the following if "4WD ACTUATOR RLY [C1205]" is displayed in self-diagnosis results of CONSULT-III.
1.CHECK AWD SOLENOID SYSTEM
Perform self-diagnosis. Scan Tool Testing and Procedures.
Is the "4WD SOLENOID [C1204]" displayed?
YES - Perform trouble diagnosis for AWD solenoid. C1204.
NO - GO TO 2.
2.CHECK AWD ACTUATOR RELAY SIGNAL

With CONSULT-III
1. Turn ignition switch "ON". (Do not start engine.)
2. Select "DATA MONITOR" mode for "ALL MODE AWD/4WD" with CONSULT-III.
3. Start engine and read out ON/OFF signal of "ETS ACTUATOR".





OK or NG
OK - GO TO 4.
NG - GO TO 3.
3.CHECK AWD CONTROL UNIT
Check AWD control unit input/output signal. Pinout Values and Diagnostic Parameters.
OK or NG
OK - GO TO 4.
NG - Check AWD control unit pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace damaged parts.
4.CHECK DTC
Perform the self-diagnosis, after driving a vehicle for a while.
OK or NG
OK - INSPECTION END
NG - Replace AWD control unit.