Diagnosis Procedure

IGNITION SIGNAL


Diagnosis Procedure

1.CHECK IGNITION COIL POWER SUPPLY CIRCUIT-I
1. Turn ignition switch OFF, wait at least 10 seconds and then turn it ON.
2. Check the voltage between ECM harness connector terminals as per the following.





Is the inspection result normal?
YES - GO TO 2.
NO - Go to Diagnosis Procedure.
2.CHECK IGNITION COIL POWER SUPPLY CIRCUIT-II
1. Turn ignition switch OFF.
2. Disconnect condenser harness connector.
3. Turn ignition switch ON.
4. Check the voltage between condenser harness connector and ground.





Is the inspection result normal?
YES - GO TO 5.
NO - GO TO 3.
3.CHECK IGNITION COIL POWER SUPPLY CIRCUIT-III
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R harness connector E7.
3. Check the continuity between IPDM E/R harness connector and condenser harness connector.





4. Also check harness for short to ground and short to power.
Is the inspection result normal?
YES - Go to Diagnosis Procedure.
NO - GO TO 4.
4.DETECT MALFUNCTIONING PART
Check the following.
- Harness connectors E40, F39
- Harness for open or short between IPDM E/R and condenser
- Repair open circuit, short to ground or short to power in harness or connectors.
5.CHECK CONDENSER GROUND CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Check the continuity between condenser harness connector and ground.





3. Also check harness for short to power.
Is the inspection result normal?
YES - GO TO 6.
NO - Repair open circuit or short to power in harness or connectors.
6.CHECK CONDENSER
Testing and Inspection
Is the inspection result normal?
YES - GO TO 7.
NO - Replace condenser.
7.CHECK IGNITION COIL POWER SUPPLY CIRCUIT-IV
1. Reconnect all harness connectors disconnected.
2. Disconnect ignition coil harness connector.
3. Turn ignition switch ON.
4. Check the voltage between ignition coil harness connector and ground.





Is the inspection result normal?
YES - GO TO 9.
NO - GO TO 8.
8.DETECT MALFUNCTIONING PART
Check the following.
- Harness connector F39
- Harness for open or short between ignition coil and harness connector F39
- Repair or replace harness or connectors.
9.CHECK IGNITION COIL GROUND CIRCUIT FOR OPEN AND SHORT
1. Turn ignition switch OFF.
2. Check the continuity between ignition coil harness connector and ground.





3. Also check harness for short to power.
Is the inspection result normal?
YES - GO TO 10.
NO - Repair open circuit or short to power in harness or connectors.
10.CHECK IGNITION COIL OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT
1. Disconnect ECM harness connector.
2. Check the continuity between ignition coil harness connector and ECM harness connector.





3. Also check harness for short to ground and short to power.
Is the inspection result normal?
YES - GO TO 11.
NO - Repair open circuit, short to ground or short to power in harness or connectors.
11.CHECK IGNITION COIL WITH POWER TRANSISTOR
Testing and Inspection.
Is the inspection result normal?
YES - GO TO 12.
NO - Replace malfunctioning ignition coil with power transistor. Exploded View.
12.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- INSPECTION END