Removal And Installation

BRAKE PEDAL


Removal and Installation


REMOVAL

CAUTION:
Never removing brake pedal stroke sensor. (With pre-crash seat belt)
1. Perform 4WAS front actuator neutral position adjustment (with 4WAS). Description Work Procedure (Pattern 1) Work Procedure (Pattern 2), "Work Procedure
(Pattern 1)".
2. Remove the instrument lower panel LH. Removal And Installation.
3. Disconnect the brake pedal stroke sensor harness connector. (With pre-crash seat belt)
4. Disconnect the stop lamp switch harness connector and brake switch harness connectors.
5. Rotate the stop lamp switch and the brake switch counterclockwise to remove.
6. Remove the accelerator pedal (with 4WAS). Exploded View Without Distance Control Assist System Removal And Installation Without Distance Control Assist System Inspection Without Distance Control Assist System, "MODELS WITHOUT DISTANCE CON-
Exploded View With Distance Control Assist System Removal And Installation With Distance Control Assist System, "MODELS WITH DISTANCE CONTROL ASSIST SYSTEM : Removal and Installation" (with distance control assist system).
7. Remove the lower shaft (with 4WAS). Removal And Installation.
8. Remove the snap pin, and then remove the clevis pin from the clevis of brake booster.
9. Remove the BCM. Service and Repair.
10. Remove the brake pedal assembly.

CAUTION:
Hold the brake booster and master cylinder so as not to drop out or contact them other parts.
11. Perform inspection after removal. Inspection.

INSTALLATION
Note the following, and install in the reverse order of removal.
- Apply the multi-purpose grease to the clevis pin and the matching faces.

NOTE:
The clevis pin may be inserted in either direction.
- Perform adjustment after installation. Inspection.