P062F

DTC Logic


DTC DETECTION LOGIC







DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. PERFORM DTC CONFIRMATION PROCEDURE

1.Turn ignition switch ON.
2.Turn ignition switch OFF and wait at least 10 seconds.
3.Repeat step 1 and 2 for 2 times.
4.Check 1st trip DTC.
Is 1st trip DTC detected?
YES- Proceed to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK 12V BATTERY

Check 12V battery. Perform Testing and Inspection.
Is the inspection result normal?
YES- GO TO 2.
NO- Charge or replace 12V battery. Removal and Installation.

2. CHECK INTERMITTENT INCIDENT

Perform Intermittent Incident.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace error-detected parts.

3. PERFORM DTC CONFIRMATION PROCEDURE

1.Erase DTC.
2.Perform DTC confirmation procedure. .
Is DTC P062F detected again?
YES- Replace HPCM. Removal and Installation.
NO- INSPECTION END