P0806

DTC Logic


DTC DETECTION LOGIC

NOTE:
If DTC P0806 is displayed with DTC P0807, P0808, P175A, P2857, P2859 or P3149, perform the trouble diagnosis for DTC P0807, P0808, P175A, P2857, P2859 or P3149. Testing and Inspection .






DTC CONFIRMATION PROCEDURE


1. PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- GO TO 2.

2. PER FORM DTC CONFIRMATION PROCEDURE

1.Set the vehicle to READY.
2.Start engine, and warm engine coolant temperature to 70 �C (158 �F).
3.Drive the vehicle.

CAUTION:
Always drive the vehicle at a safe speed.
4.Drive the vehicle with a motor.

CAUTION:
Always drive the vehicle at a safe speed.
5.Check DTC.
Is DTC detected?
YES- Proceed to .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK CLUTCH 1 STROKE SENSOR FUNCTION

With CONSULT
1.Select "DATA MONITOR" mode of "EV/HEV" using CONSULT.
2.Set the vehicle to READY and engine stop state.
3.Check that the "CLUTCH 1 STROKE SENSOR" indication voltage as per the following condition.





Without CONSULT
1.Set the vehicle to READY and engine stop state.
2.Check the voltage between HPCM terminals as per the following condition.





Is the inspection result normal?
YES- Perform Intermittent Incident.
NO- GO TO 2.

2. CHECK SUB ELECTRIC OIL PUMP

P188C.
Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace error-detected parts.

3. CHECK ATF LINE

Check ATF line for clogging.
Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace error-detected parts.

4. CHECK CLUTCH 1 DISC

Check clutch 1 disc thickness. Inspection.
Is the inspection result normal?
YES- Replace transmission assembly. Removal and Installation.
NO- Replace clutch disc and cover. Removal and Installation.