HPCM Work Procedure

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

HPCM : Work Procedure


1. PERFORM HPCM RECOMMUNICATING FUNCTION

1.Install HPCM.
2.Contact backside of registered Intelligent key* to push-button ignition switch while brake pedal is depressed, then turn ignition switch ON.
*: To perform this step, use the key that is used before performing HPCM replacement.
3.Maintain ignition switch in the ON position for at least 5 seconds.
4.Turn ignition switch OFF.
5.Check that the vehicle can be set to READY.
- GO TO 2.

2. PERFORM ADDITIONAL SERVICE WHEN REPLACING HPCM

Perform the following procedure, Work Procedure.
- END