Harness Connector

COMPONENT PARTS

Harness Connector

NOTE:
The color of the high voltage harnesses is orange. Do not carelessly touch these harnesses and connector.

HARNESS CONNECTOR (TAB-LOCKING TYPE)

- The tab-locking type connectors help prevent accidental looseness or disconnection.
- The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the figure below.

CAUTION:
To prevent damage to the parts, never pull the harness or wires when disconnecting the connector.
[Example]






HARNESS CONNECTOR (SLIDE-LOCKING TYPE)

- A new style slide-locking type connector is used on certain systems and components, especially those related to OBD.
- The slide-locking type connectors help prevent incomplete locking and accidental looseness or disconnection.
- The slide-locking type connectors are disconnected by pushing or pulling the slider. Refer to the figure below.
- After connecting the connector, check that the slider is located in the correct position.

CAUTION:
- To prevent damage to the parts, never pull the harness or wires when disconnecting the connector.
- To prevent damage to the parts, be careful not to damage the connector support bracket when disconnecting the connector.
[Example]






HARNESS CONNECTOR (LEVER LOCKING TYPE)

- Lever locking type harness connectors are used on certain control units and control modules such as ECM, ABS actuator and electric unit (control unit), etc.
- Lever locking type harness connectors are also used on super multiple junction (SMJ) connectors.
- Always confirm the lever is fully locked in place by moving the lever as far as it will go to ensure full connection.

CAUTION:
Always confirm the lever is fully released (loosened) before attempting to disconnect or connect these connectors to avoid damage to the connector housing or terminals.











HIGH VOLTAGE HARNESS CONNECTOR (2-STEP TYPE, 3-STEP TYPE)

- 2-step type and 3-step type connectors are used for specific high voltage parts.
- For secure connection, check that the slider is pressed all the way when connecting the high voltage connector.
2-Step Type










3-Step Type