B2604

Description

BCM confirms the shift position with the following 4 signals.
- Selector lever
- Transmission range switch
- P position signal from IPDM E/R (CAN)
- P position signal from TCM (CAN)


DTC Logic


DTC DETECTION LOGIC

NOTE:
- If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to
"BCM : DTC Logic" Security System.
- If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to
"BCM : DTC Logic" Security System.






DTC CONFIRMATION PROCEDURE


1. PERFORM DTC CONFIRMATION PROCEDURE

1.Start engine and wait 1 second or more.
2.Check "Self-diagnostic result" using CONSULT.
Is DTC detected?
YES- Go to "Diagnosis Procedure" .
NO- INSPECTION END


Diagnosis Procedure


1. CHECK DTC WITH TCM

Check "Self diagnostic result" using CONSULT.
Are any DTC detected?
YES- Refer to "DTC Index" Testing and Inspection.
NO- GO TO 2.

2. CHECK TRANSMISSION RANGE SWITCH CIRCUIT 1

1.Turn ignition switch OFF.
2.Disconnect A/T assembly connector and BCM connector.
3.Check continuity between A/T assembly harness connector and BCM harness connector.





4.Check continuity between A/T assembly harness connector and ground.





Is the inspection result normal?
YES- GO TO 3.
NO- Repair or replace harness.

3. CHECK TRANSMISSION RANGE SWITCH CIRCUIT 2

1.Disconnect TCM connector.
2.Check continuity between TCM harness connector and A/T assembly harness connector.





3.Check continuity between TCM harness connector and ground.





Is the inspection result normal?
YES- GO TO 4.
NO- Repair or replace harness.

4. CHECK INTERMITTENT INCIDENT

Refer to "Intermittent Incident" Intermittent Incident.
- INSPECTION END