Roll Bar: Service and Repair

Roll Over Protection Unit

Removal
1 Remove the cover and disconnect the battery ground cable. For additional information, refer to Specifications
2 Make the SRS system safe. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering
3 Remove the rear seat backrest. For additional information, refer to Rear Seat Backrest Rear Seat Backrest




4 Release the rear seat backrest trim panel.
- Remove the 2 clips.
- Remove the 2 bolts.
- Position the rear seat backrest trim panel aside.




5 Remove the rear seat backrest retaining bracket.
- Remove the 2 nuts and 2 bolts.




6 Remove the roll over protection unit.
- Disconnect the electrical connector.
- Remove the 4 Torx bolts.

Installation
1 Install the roll over protection unit.
- Tighten the Torx bolts to 25 Nm (18 lb.ft).
- Connect the electrical connector.
2 Install the rear seat backrest retaining bracket.
- Tighten the nuts and bolts to 10 Nm (7 lb.ft).
3 Install the rear seat backrest trim panel.
- Tighten the bolts to 10 Nm (7 lb.ft).
- Install the clips.
4 Install the rear seat backrest. For additional information, refer to Rear Seat Backrest Rear Seat Backrest
5 Connect the battery ground cable and install the cover. For additional information, refer to Specifications
6 Connect WDS to the vehicle and configure a new module.