Instrument Cluster / Carrier: Service and Repair

Instrument Cluster
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures
For additional information, refer to TAS Symbol Glossary TAS Symbols Glossary
Removal

NOTE:
Removal steps in this procedure may contain installation details.
1 Fully extend and lower the steering column for access.
For additional information, refer to Battery Disconnect and Connect

Torque to: 2 Nm

NOTE:
The procedure must be carried out on both sides.

Torque to: 1.5 Nm

CAUTION: If a new instrument cluster is to be installed, the Jaguar approved diagnostic equipment must be connected prior to removal, the data must then be downloaded from it and the keys (remote control handsets) set into default mode. Failure to follow this instruction will result in permanent damage to the keys.

Installation
1 To install, reverse the removal procedure.
2 Configure the instrument cluster and ignition keys using the diagnostic tool.