Camshaft: Service and Repair

Camshafts
This is a "Trustmark Authoring Standards (TAS) Repair Procedure"
- TAS style procedures can be identified by steps that have no accompanying step text and the magenta color of the electrical connectors and fasteners such as nuts, bolts, clamps or clips.
- TAS removal and installation procedures use a sequence of color illustrations to indicate the order to be followed when removing/disassembling or installing/assembling a component.
- Many of the TAS procedures will have the installation information within the removal steps.
- The TAS color illustrations use a variety of symbols to indicate important details of the procedures. It is important to understand these symbols in order to properly used the TAS procedures.
Refer to How to Use TAS Procedures and TAS Symbol Glossary at Vehicle | Description and Operation for additional information on these TAS procedures.
For additional information, refer to How to Use TAS Procedures How to Use TAS Procedures

Removal

NOTE:
Some illustrations may show the engine removed for clarity.

NOTE:
Removal steps in this procedure may contain installation details.

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.
For additional information, refer to Specifications [1][2]Battery

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
For additional information, refer to Timing Chain Service and Repair





CAUTION: Note the fitted position of the component prior to removal.




Loosen each bolt 2 turns at a time until all bolts are removed.




2 Remove the special tool.
Special Service Tool




Locking Tool, Camshaft, JLR-303-1600





CAUTION: Note the fitted position of the component prior to removal.





CAUTION: Note the fitted position of the component prior to removal.

Installation






CAUTION: Make sure that these components are installed to the noted removal position.

NOTE:
Lubricate the camshafts and the camshaft bearing caps with oil meeting Land Rover specification prior to installation.





CAUTION: Apply sealant WSK-M2G348-A2 in a 1-1.5mm diameter on the cylinder head and camshaft caps as shown. The components must be installed and tightened within 60 minutes of sealant application.





CAUTION: Make sure that the camshafts and camshaft bearing caps are installed in their original locations.

CAUTION: Make sure that the piston No. 1 is at top dead center (TDC) before installing the camshafts.

Step 1: 7 Nm

Step 2: 16 Nm





Torque to: 10 Nm
For additional information, refer to Timing Chain Service and Repair
For additional information, refer to Battery Removal and Replacement