Fender Splash Shield

Fender Splash Shield

Removal

All vehicles
1
WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
Raise and support the vehicle.




2 Remove the fender seal




3 Remove the fender splash shield.
- Release the 6 clips.
- Remove the 7 screws.
- Disconnect the electrical connector.




4
NOTE:
Do not disassemble further if the component is removed for access only.
Remove the tire pressure antenna.
- Release the 2 clips.

Vehicles with supercharger




5
NOTE:
Right-hand shown, left-hand similar.
Remove fender splash shield grille.
- Release the 3 clips and remove the cover.

Installation

Vehicles with supercharger
1 Install the fender splash shield grille.
- Secure with the clips.

All vehicles
2 Install the tire pressure antenna.
3 Install the fender splash shield.
- Tighten the screws.
- Install the clips.
- Connect the electrical connector.
4 Install the fender seal.