Cooling System Draining, Filling and Bleeding

Cooling System Draining, Filling and Bleeding
For additional information, refer to Air Cleaner Outlet Pipe T-Connector Air Cleaner Outlet Pipe T-Connector

WARNING: Make sure to support the vehicle with axle stands.
1 Raise and support the vehicle.
For additional information, refer to Engine Undershield Engine Undershield

WARNING: Since injury such as scalding could be caused by escaping steam or coolant, do not remove the filler cap from the coolant expansion tank while the system is hot.

2 Remove the 4 bolts.

CAUTION: Be prepared to collect escaping coolant.
3 Position a container to collect the fluid.

CAUTION: Be prepared to collect escaping coolant.
4 Install the lower coolant hose to the radiator.

CAUTION: Be prepared to collect escaping coolant.

CAUTION: Install a new seal.

Torque to: 50 Nm

5 Install the coolant hose.

6 Install the coolant hose.

7 Install the LH splash shield.

Torque to: 10 Nm
For additional information, refer to Engine Undershield Engine Undershield
1 Lower the vehicle.
For additional information, refer to Air Cleaner Outlet Pipe T-Connector Air Cleaner Outlet Pipe T-Connector

NOTE:
Some variation in the illustrations may occur, but the essential information is always correct.

CAUTION: Anti-freeze concentration must be maintained at 50%.

CAUTION: Be prepared to collect escaping coolant.
2 Fill the coolant expansion tank until coolant appears through the bleed ports.

CAUTION: Be prepared to collect escaping coolant.
3 Fill the coolant expansion tank until coolant appears through the bleed ports.

CAUTION: Be prepared to collect escaping coolant.
4 Fill the coolant expansion tank until coolant appears through the bleed ports.
5 Set the heater controls to maximum.
6 Start the engine and continue to fill the coolant until the maximum level is reached.
7 Increase the engine speed to 1500 rpm.
8 Check if the front heater is warm after 2 minutes, if warm proceed to step 23
9 If not, turn the engine off for 10 seconds and then start the engine and return to step 20.

CAUTION: Correct installation of the Coolant expansion tank cap can be obtained by tightening the cap until an audible click is heard.

10 Switch the heater off.

11 Raise the engine speed to 2000 RPM for eight minutes.

CAUTION: Switch off the engine and allow the coolant temperature to go cold.

12 Switch the engine off and allow to cool.

13 Visually check the engine and cooling system for signs of coolant leakage.

WARNING: When releasing the cooling system pressure, cover the coolant expansion tank cap with a thick cloth.

CAUTION: Since injury such as scalding could be caused by escaping steam or coolant, make sure the vehicle cooling system is cool prior to carrying out this procedure

CAUTION: Make sure the coolant level remains above the "COLD FILL RANGE" lower level mark.

NOTE:
When the cooling system is warm, the coolant will be approximately 10mm above the upper level mark on the expansion tank with the cap removed.

14 Check and top-up the coolant if required.