Dynamic Response Module

Dynamic Response Module

Removal

NOTE:
The dynamic response module is always located on the driver's side of the vehicle.
1 Remove the cowl side trim panel. For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel




2 Remove the closing trim panel.
- Release the clip.
- Remove the 2 screws.
- Disconnect the electrical connector.




3 Remove the dynamic response module.
- Remove the 2 bolts.
- Disconnect the 2 electrical connectors.

Installation
1 Install the dynamic response module.
- Connect the electrical connectors.
- Tighten the 2 bolts to 4 Nm (3 lb.ft).
2 Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
3 Install the cowl side trim panel. For additional information, refer to Cowl Side Trim Panel Cowl Side Trim Panel
4 Initiate a new control module using T4.