P0328

DTC P0327 Knock Sensor 1 Circuit Low Input (Bank 1 or Single Sensor)
DTC P0328 Knock Sensor 1 Circuit High Input (Bank 1 or Single Sensor)
DTC P0332 Knock Sensor 2 Circuit Low Input (Bank 2)
DTC P0333 Knock Sensor 2 Circuit High Input (Bank 2)

DESCRIPTION

DTC Detection Condition:

A flat type knock sensor (non-resonant type) has the structure that can detect the vibration in a wider band of frequency from about 6 kHz to 15 kHz and has the following features.

Knock sensors are fitted on the right bank and left bank of the cylinder block to detect engine knocking. Each knock sensor contains a piezoelectric element which generates voltage when it becomes deformed. Generation of the voltage occurs when the cylinder block vibrates due to a knocking. If an engine knocking occurs, the ignition timing is retarded in order to suppress the knocking.

Reference: Inspection using the oscilloscope.








The correct waveform is as given.

MONITOR DESCRIPTION
The knock sensor, located on the cylinder block, detects an engine knocking. When an engine knocking occurs, the sensor picks-up vibrates. When the ECM (Included in HV control ECU) detects the voltage in this frequency range, it retards the ignition timing to suppress the engine knocking.

The ECM (Included in HV control ECU) also senses background engine noise with the knock sensor and uses this noise to check for faults in the sensor. If the knock sensor signal level is too low for more than 10 seconds, and if the knock sensor output voltage is out of normal range, the ECM interprets this as a fault in the knock sensor and sets a DTC.

Monitor Strategy:

Typical Enabling Conditions:

Typical Malfunction Thresholds:

Wiring Diagram:

INSPECTION PROCEDURE

HINT:
- DTC P0327 and P0328 are for the bank 1 knock sensor circuit.
- DTC P0332 and P0333 are for the bank 2 knock sensor circuit.
- Read freeze frame data using the intelligent tester. The ECM (Included in HV control ECU) records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

Step 1-2:

Step 2(Continued)-3:

Step 4-5:

Step 5(Continued):