Vehicle Stability Control System

BRAKE CONTROL: VEHICLE STABILITY CONTROL SYSTEM:

DIAGNOSTIC TROUBLE CODE CHART
HINT:
- If a trouble code is displayed during the DTC check, check the circuit indicated by the DTC.
- Inspect the fuse and relay before investigating the trouble areas as shown in the table below.

DTC Chart of ABS:





















(*1), (*2):
Even after the trouble areas are repaired, the ABS warning light will not go off unless the following operations are performed.

- (*1):
(a) Drive the vehicle at 20 km/h (12 mph) for 30 seconds or more and check that the ABS warning light goes off.
(b) Clear the DTC.
- (*2):
(a) Keep the vehicle in a stationary condition for 5 seconds or more and depress the brake pedal lightly 2 or 3 times.
(b) Repeat the above operations 3 times or more and check that the ABS warning light goes off.
(c) Clear the DTC.
HINT:
- In some cases, Techstream cannot be used when the ABS warning light remains on.
- When U0073/94, U0100/65, U0123/62, U0124/95 or U0126/63 is output, inspect and repair the trouble areas indicated by these codes first.

(*3): The skid control buzzer sounds.

DTC Chart of VSC:









HINT: In some cases, Techstream cannot be used when the VSC TRAC warning light remains on.